Magnizon-Pure Sine Wave Inverter 48VDC 230V, 50/60Hz, 8000w



Provide Pure Sine Wave power for all your alternative energy needs with the MAGNIZON APS-8048SW-LCD. This inverter/charger supplies 8000 watts of continuous 230V /50Hz AC power. Reliable large transformer design and frequency control powers very much compatible to all varieties of loads: resistive loads such as refrigerators, motors, pumps compressors and laser printers as well as electronic loads like TV’s, Computers, power tool and battery chargers. Smart micro controller based 3-stage charging system properly charge and maintain battery bank. The charge rate is selectable so you can use a variety of battery sizes and types to fit your back up time requirements.


Provides safe and reliable power protect for the following equipment:

  • Equipment is Office and Public
  • Home Appliances
  • IT Network Equipment
  • Manufacture Control System
  • Solar Energy System
  • Oil field and Fieldwork

Key Features

  • 48V DC or 230V AC input; 230V, 50 Hz output (hardwired)
  • 8KWcontinuous output, 24000 watts peak output
  • Microprocessor controlled Smart UPS & Solar operational mode
  • 4-Step Progressive Charging & 7-Battery Type Selector
  • Fully compatible for Solar/Wind solutions for Hybrid configuration
  • Pure sine wave output with LCD display
  • High Efficiency Using Line-Interactive Circuit Topology(Full Bridge Topology)
  • Quiet, high efficiency operation, high surge capacity and low idle current

On inverter

  • High overload ability
  • Low battery voltage trip selectable, extracting max power from various batteries with different protections
  • Low quiescent current, selectable sensing cycle to reduce power consumption

On battery charger

  • 3-step intelligent battery charging
  • 8 preset battery type selector plus de-sulphation for totally flat batteries
  • Powerful charge rate up to 100Amp ,selectable charging current
  • PFC(Power Factor Correction) for charger, less power consumption than conventional units

On Transfer

  • Delay before transfer, extra protections for loads under generator mode
  • Input AC voltage range selectable, for different kinds of loads
  • 8 ms typical transfer time, guarantees power continuity
  • 30A/40A through current ability
  • Output voltage regulation optional

On remote control & other features

  • Ability to switch the unit on/off
  • Ability to select/deselect power saver mode
  • 17 alarms/warnings, informative for easier operation and trouble-shooting
  • LCD status display available
  • RS232 communication port optional

**Built in input and output breakers.


Input Phase & Wave Form Single Phase & Sine wave (Utility or Generator)
Nominal Voltage 220/230/240V AC
Input AC voltage Window 154-273C AC
Line Low Transfer 154V +/- 4%
Low Voltage Re engage 164V +/- 4%
High Voltage Trip 273V +/- 4%
High Voltage Re engage 263V +/- 4%
Max Input AC Voltage 270V
Nominal Input Frequency 50Hz or 60Hz (Auto detect)
Low frequency trip 40Hz
High frequency trip 80Hz
Output Connection type Hardwire via built in junction box with cover plate
Output Wave form & Phase Pure Sine wave & Single Phase (Bypass mode sync to Input)
Power Factor 1
Nominal Output Voltage RMS 220/230/240V AC (L-N) (same as input on Bypass mode)
Output Voltage regulation +/-10% RMS (bypass mode sync to input)
Output frequency 50Hz +/-0.3Hz or 60Hz+/-0.3Hz
Nominal Efficiency >88%
Output Connection type Hardwire via built in junction box with cover plate
Surge rating/crest factor 3 times of rating
Output continuous power in Watts 8000
Output continuous power in VA 8000
Short circuit protection Yes, fault after 10sec
Nominal Input Voltage Dc 48V DC
Minimum start voltage Dc 40V DC
Low battery Alarm 44V DC
Low battery trip 40V DC
High Voltage alarm 64V DC
Over Charge Voltage 62.8V DC
Max Charging Current 75A DC
DC Connection type DC INPUT: Set of 2 DC bolt-down terminals. AC INPUT: Hardwire via built in junction box with cover plate
Transfer Time 6-10mSec
Line Mode >95%
Battery Model >85%
Power Save Available when the load is less than 75W
4-LED Status Display Charge, Line, Inverter & fault
LCD Display Input Voltage, Output Voltage, Frequency, Battery voltage, Load, Temperature, Charge current & Fault
Switch Selector Saving Mode is On/Off when push the switch forward/backwards, keeping it horizontal is turning the inverter Off
Audible Alarm Sounding when the heat sink's temperature is over 105deg C and shutdown after 30 seconds
Protections Low Battery, Over charging, Over temp & over load
Communications RJ11/RS232 (optional)
Operating Temp 0-40deg C
Humidity 0-95% RH (non-condensing)
Audible Noise <60dB
Size (in mm) 549x450x202
Weight 56Kgs
Warranty 2 Year limited warranty Extendable up to 4 years
Safety EMC/CE/ROHS/ISO9001
Disturbance at Mains Terminals EN61000-6-3:2007+ A1: 2011+ AC:2012
Radiated Disturbance EN61000-6-3:2007+ A1: 2011+ AC:2012
Harmonic Current Emission EN61000-3-12: 2011
Voltage fluctuations & flickering EN61000-3-11: 2000
Electrostatic Discharge (ESD) IEC 6100-4-2:2008
Radio-frequency & continues radiated disturbances IEC 6100-4-3:2006 + A1:2007 + A2:2010
EFT/B Immunity IEC 6100-4-4:2012
Surge immunity IEC 6100-4-5:2014
Conducted RF immunity IEC 6100-4-6:2013
Power frequency magnetic field IEC 6100-4-8:2009
Voltage DIP >95% reduction,IEC 6100-4-11:2004
Voltage DIP >30% reduction,IEC 6100-4-11:2004
Voltage Interruption IEC 6100-4-11:2004

Similar Products


Provide Pure Sine Wave power for all your alternative energy needs wi...


Provide Pure Sine Wave power for all your alternative energy nee...


Provide Pure Sine Wave power for all your alternative energy nee...


Provide Pure Sine Wave power for all your alternative energy need...


Provide Pure Sine Wave power for all your alternative energy nee...

Optional Products